Which size door?

1. up an over garage doors:

Any garage door size is expressed as the internal frame size. This is usually slightly larger than the actual door panel.

• For example:

If the internal frame to frame width is 7’0” and the floor to underside of frame crossbar is 6’6” – door size you need to order is 7’0” x 6’6”.

To self quote and/or order your door:
• Under “View Products”, please click on the type of door you want and follow the on screen instructions.

After you’ve placed your order:
• All customers are phoned once order is placed to double check all sizes and details of order. Please endeavour to have the Self Survey Form completed at this point.

• Most up and over garage doors require a 70 mm square timber goalpost frame OR factory fitted steel frame.
The door size does not include the size of this frame.

• There are two ways of fitting an up and over garage door. Please see diagram A and B.

2. Sectional garage doors.

The size of a sectional garage door is expressed as the internal frame size.
• Sectional doors are fitted to the rear of the brick pillars.
• If fitting between the brick pillars – please phone us on 01691 670394.
• On Hormann sectional doors space needed on back of pillars is minimum 90 mm either side of the door width.
• Hormann sectional doors come complete with the 90 mm steel frame (i.e.) two uprights and a crossbar.

• Minimum ceiling height – data in the following table is based on remote controls being used. If using other make of remote control please add approx 10 mm to the sizes below.

Please note that if low headroom gear needed you can add it to your order by going to Accessories.